Summa F1612 General Overview
Summa F1612 General Overview
Check the compressor fluids
Empty water from the water catcher
Clean blades if dirty and check condition
Software problems; restart computer, restart Summa
Embedded Files
Cutting Acrylic and Dibond
Cutting Acrylic and Dibond
OUTDATED INFORMATION
6mm with 4mm bit
SPEED: 60mm/sRPM: 18000MODE: Conventional
Multipass
Depth: 1mm
Cleaning pass
Depth: 1mmSpeed: 20mm/s
Polishing Pass
Speed: 10mm/sRPM: 18000
Max Media should not exceed 3x the diameter of the bit
Acrylic should not be cut any higher than 18000RPM
Camera/Kisscut Calibration
Camera/Kisscut Calibration
Modules > Camera > slot 2 or slot 3
Machine will cut squares out
Weed the outside square carefully
Press OK
Camera will read and save the location of the small cut square
Press APPLY
Done
Page updated
Google Sites
Report abuse